Datacard Group ImageCard SelectTM and UltraGrafix SelectTM Printers - Manual (Page 99)

User’s Guide for ImageCard® Select™ and UltraGrafix® Select™ Printers
A
A
Safety and compliance
This appendix presents:
•
Regulatory compliance information
•
Safety information
•
Trademark acknowledgments
Regulatory compliance
Notice for USA (FCC notice)
This equipment generates, uses, and can radiate radio frequency energy. If it is not
installed and used in accordance with this instruction manual, it may interfere with
radio communications. This equipment has been tested and found to be within the
limits for Class A computing devices, pursuant to Subpart J of Part 15 of FCC rules,
designed to provide reasonable protection against radio interference in a commercial
environment. Operation of this equipment in a residential environment may possibly
cause interference. In the event of interference, the user, at their own expense, will be
required to take whatever measures are necessary to correct the problem.
Notice for Canada
This digital apparatus does not exceed the Class A limits for radio noise for digital
apparatus set out in the Radio Interference Regulations of the Canadian Department
of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les
limites applicables aux appareils numériques de la classe A prescrites dans le
Règlement sur le brouillage radioélectrique édicté par le ministère des
Communications du Canada.
Notice for Europe
We hereby certify that the Datacard® Select™ Class photo ID printer complies with
EMC Directive 89/336/EEC.This printer conforms to Class A of EN 55022. Operation
of this equipment in a residential environment may possibly cause interference. In the
event of interference, the user, at their own expense, will be required to take whatever
measures are necessary to correct the problem.
Notice to Users of Printers Equipped with Contactless Smart
Card Coupler
The contactless smart card coupler emits radio-frequency waves and must be used as
installed and recommended by Datacard, the printer manufacturer. You may not
modify the coupler or how it is used without the written permission of Datacard. You
may not operate the printer after modifying the coupler or its method of operation.