Datacard Group ImageCard SelectTM and UltraGrafix SelectTM Printers - Manual (Page 133)

D-3
User’s Guide for ImageCard® Select™ and UltraGrafix® Select™ Printers
Magnetic Stripe settings used by the Select
printer
The following table presents technical details that apply to encoding magnetic stripe
data.
Magnetic Stripe Setup
Do the following to set up the printer and printer driver to encode magnetic stripes on
cards:
•
Use cards with magnetic stripes when making a printer test card.
•
Determine the coercivity to use. Usually, the coercivity is system-wide decision:
magnetic stripe readers are likely to require a specific coercivity value. Card stock
is purchased to match that coercivity value. Set the coercivity in the printer driver.
•
Select the encoding format. If a custom format, such as triple-IATA, is used, select
Binary or “Use Printer coercivity” in the printer driver.
IATA ABA TTS NTT Binary
Character Differential 32 48 48 0 0
Start Sentinel (SS)
(ASCII character) % (37) ; (59) ; (59) 127 None
End Sentinel (ES)
(ASCII character) ? (63) ? (63) ? (63) 127 None
Lowest ASCII Character space (32) 0 (48) 0 (48) (1) 0
Highest ASCII Character _ (95) ? (63) ? (63) (126) 255
Character-level parity (VRC) Odd Odd Odd Even None
Cumulative parity (LRC) Even Even Even Even None
Density in bits per inch 210 75 210 210 210
Data bits per character 6 4 4 7 8
Maximum number of
encodable characters (not
including start and end
sentinel or LRC) 76 37 104 69 33
Encoding direction SS first SS first SS first SS last SS first
Start sentinel adjustment 310 320 310 450 310