Connect the power cord – Datacard Group ImageCard SelectTM and UltraGrafix SelectTM Printers User Manual
Page 86
7-6
Install the printer
User’s Guide for ImageCard® Select™ and UltraGrafix® Select™ Printers
2
Connect the serial cable to the outside printer port (Figure 7-4) if a contactless
module is installed in the printer.
Figure 7-4: Connect the smart card serial cable
3
Use two smart card serial cables if both ports are installed on the printer (the
smart card module contains both contactless
(inside port) and contact (outside
port) couplers).
4
Connect the other end of the smart card serial cable(s) to the appropriate serial
port on the PC. See information for your smart card application for the correct PC
port(s) to use.
5
Verify that serial port settings are correct. See “PC settings” on page C-1.
♦
Connect the power cord
1
Attach the power cord to the power receptacle on the back of the printer (step 1 in
Figure 7-5).
Figure 7-5: Connect the power cord
Inside
Outside
2
1