Datacard Group ImageCard SelectTM and UltraGrafix SelectTM Printers - Manual (Page 108)

B-6
User’s Guide for ImageCard® Select™ and UltraGrafix® Select™ Printers
Card storage specifications
The cards should be stored in a cool, dry, and dark place. Excessive light can cause
yellowing of cards on exposed edges. Keep cards in their original packaging.
Cards should be at room temperature when they are installed in the printer and used.
If cards are stored in a cooler environment than the printer, allow them to reach room
temperature before using.
Cleaning supplies
The Select printer uses the following cleaning supplies.
•
leaning cards
•
Replaceable cleaning sleeves
•
Printhead cleaning pen
Printer cleaning card
Use a printer cleaning card to remove particles left by printing supplies inside the
Select printer. Use a printer cleaning card at the interval you set, such as every 250
cards (see “Working with printer settings and data” on page 3-2).
Printer cleaning cards are sold in packages of 10. The package part number is
557297-001. Printer cleaning cards are also sold as part of cleaning kits, described
below.
Figure B-3: Printer cleaning card
If the printer does not have a magnetic strip module, you can use cleaning card
part number 548714-001.
Replaceable cleaning sleeve
Use a replaceable cleaning sleeve on the continuous cleaning roller. Change the
replaceable cleaning sleeve before you run a printer cleaning card.
The replaceable cleaning sleeve is sold in packages of 5. The package part number is
549716-001. The replaceable cleaning sleeve is also available as part of a cleaning
kit.
i