Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 266)

Appendix E - Parameters Summary
BreezeACCESS VL System Manual
234
Parameter Unit Range Default Run-Time
TCP RTP/RTCP Prioritization AU, SU „ RTP & RTCP
„ RTP
Only
RTP & RTCP No
Low Priority Traffic Minimum
Percent AU, SU 0 – 100 (%) 0 (%) Yes
Wireless Link Prioritization
Option* AU „ Disable
„ Enable Disable Yes
Low Priority AIFS* AU 3-50 3 Yes
Number of HW Retries for
High Priority Traffic* AU 1-14 10 Yes
Number of HW Retries for
Low Priority Traffic* AU 1-14 10 Yes
AU Burst Duration for High
Priority Traffic* AU 0-40 (in 0.25 milliseconds units) 16 (4 milliseconds) Yes
AU Burst Duration for Low
Priority Traffic* AU 0-40 (in 0.25 milliseconds units) 20 (5 milliseconds) Yes
SU Burst Duration for High
Priority Traffic* AU 0-40 (in 0.25 milliseconds units) 8 (2 milliseconds) Yes
SU Burst Duration for Low
Priority Traffic* AU 0-40 (in 0.25 milliseconds units) 20 (5 milliseconds) Yes
DRAP Support AU „ Disable
„ Enable Enable No
UDP Port AU 8000–8200 8171 No
Maximum Number Of Voice
Calls AU 1–255 40 No
DRAP TTL AU 1–255 (seconds) 10 (seconds) No
* Wireless Link Prioritization parameters are applicable only for units with a license for this
feature
E.1.8 Security Parameters
Parameter Unit Range Default Run-Time
Authentication Algorithm* AU, SU „ Open system
„ Shared Key
Open system No
Data Encryption Option* AU, SU „ Disable
„ Enable Disable No
Security Mode* AU, SU „ WEP
„ AES
OCB
„ FIPS-197**
WEP No
Default Key SU 1-4 1 No
Default Multicast Key AU 1-4 1 No
Key # 1 to Key # 4 AU, SU 32 hexadecimal digits 0…0 (all 0=no key) No
Promiscuous Authentication AU „ Disable
„ Enable Disable Yes
(Disable
after reset)
* Applicable only if supported by the Sub-Band.
** The FIPS-197 option is available only in units with HW revision C or higher that have the
applicable license.