Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 261)

Parameters Summary
BreezeACCESS VL System Manual
229
Parameter Unit Range Default Run-Time
Spectrum Analysis
Channel Scan Period AU, SU 2 – 30 seconds 5 seconds Yes
(Configured
per
analysis)
Spectrum Analysis Scan
Cycles AU, SU 1 – 100 cycles 2 cycles Yes
(Configured
per
analysis)
Automatic Channel
Selection AU „ Disable
„
Enable
Disable Yes
Lost Beacons Watchdog
Threshold AU 100 – 1000, 0 means Not
Used 218 Yes
Noise Immunity State
Control AU, SU „ Automatic
„ Manual Automatic Yes
Noise Immunity Level AU, SU 0 – 4
Use only 0 or 4 0 Yes
Spur Immunity Level AU, SU 0 – 7 0 Yes
OFDM Weak Signal AU, SU 0 (not active) or 1 (active) 0 Yes
Pulse Detection
Sensitivity AU, SU „ Low
„ High Low Yes
Noise Floor Calculation
Mode AU, SU „ Fully Automatic
„ Forced
„ Automatic
with Minimum
Value
Fully Automatic Yes
Noise Floor Forced Value AU, SU -107 to -55 (dBm) 5 MHz bandwidth: -102
10 MHz bandwidth: -99
20 MHz bandwidth: -96 Yes
* Not applicable if only one Sub-Band is available for the applicable Country Code
** Applicable only if DFS is supported by the Sub-Band
*** Configurable only in units without an integral antenna.