Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 105)

Configuring Basic Parameters
Commissioning
73
3.1.3 Transmit Power Compliance With Regulations
CAUTION
In regions where local radio regulations limit the maximum transmit power of the unit the installer is
responsible to properly set the Antenna Gain parameter (if configurable) according to the actual
antenna being used. This will limit the upper limits of the Tx Power parameter in the AU and the
Maximum Tx Power in the SU (where applicable) to the value of “Permitted EIRP-Antenna Gain”.
The Tx Power parameter in the AU and the Maximum Tx Power in the SU (where applicable) should
not exceed the Permitted EIRP-Antenna Gain, according to the following table:
Table 3-2: Regulation Maximum EIRP
Country Code Maximum EIRP (dBm)
20 MHz Bandwidth 10 MHz Bandwidth 5 MHz Bandwidth
Japan 4.9 GHz 34 34 (NOTE 1) NA
FCC 5.3 GHz 30 (NOTE 3) 27 (NOTE 2) NA
FCC 5.4 GHz 30 27 NA
ETSI 5.4 GHz 30 27 NA
ETSI-F 5.4 GHz 30 27 NA
Australia 5.4 GHz 30 27 NA
Universal 5.4 GHz AU: 38
SU: 49
AU: 38
SU: 49
NA
FCC 5.8 GHz AU: 36
SU: No Limit (PtMP)
AU: 36
SU: No Limit (PtMP)
NA
UK 5.8 GHz 36 33 NA
Australia 5.8 GHz 36 36 NA
India 5.8 GHz 36 33 NA
Germany 5.8 GHz 36 33 NA
Universal 5.8 GHz AU: 36
SU: No Limit (PtMP)
AU: 36
SU: No Limit (PtMP)
NA
FCC 900 MHz NA NA 36
NOTE 1 (Japan 4.9 GHz, 10 MHz Bandwidth):
In BreezeACCESS units operating in the 4.9 GHz Japan band (not B&B point-to-
point) with a 10 MHz bandwidth, the following rules must be met for full
compliance with regulations: