Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 259)

Parameters Summary
BreezeACCESS VL System Manual
227
E.1.2 IP Parameters
Parameter Unit Range Default Run-Time
IP Address AU, SU IP address 10.0.0.1 No
Subnet Mask AU, SU IP address 255.0.0.0 No
Default Gateway Address AU, SU IP address 0.0.0.0 No
DHCP Option AU, SU „ Disable
„ DHCP Only
„ Automatic
Disable No
Access to DHCP AU, SU „ From Wireless Only
„ From Ethernet Only
„ From Both Wireless and
Ethernet
AU: From Ethernet Only
SU: From Wireless Only No
E.1.3 Air Interface Parameters
Parameter Unit Range Default Run-Time
ESSID AU, SU Up to 31 printable ASCII
characters ESSID1 No
Operator ESSID Option AU „ Disable
„ Enable Enable No
Operator ESSID AU Up to 31 printable ASCII
characters ESSID1 No
Best AU Support SU „ Disable
„ Enable Disable No
Number of Scanning
Attempts SU 1 – 255 4 No
Preferred AU MAC
Address SU MAC Address 00-00-00-00-00-00
(no preferred AU)
No
Scanning Mode SU Passive, Active Passive No
Cell Distance Mode AU Automatic, Manual Automatic No
Maximum Cell Distance AU 0-54 (Km)
0 means no compensation
0 (no compensation)
Yes
Fairness Factor AU 0 – 100 (%) 100 (%) No
Per SU Distance
Learning AU „ Disable
„
Enable
Disable Yes
Arbitration Inter-Frame
Spacing AU, SU 1-50 (time slots) 2 time slots No
Wireless Trap Threshold AU 1-100 (%) 30 (%) No
Maximum Number of
Associations AU AU-BS, AU-SA: 1-512 (1-124 if
Data Encryption Option is
enabled).
AUS-BS, AUS-SA:
1 - 8
AU-BS, AU-SA: 512
AUS-BS, AUS-SA:
8
Yes
Sub-Band Select* AU According to the Country Code 1 Yes
Frequency AU According to the Sub-Band The lowest frequency in
the Sub-Band
Yes
User Defined Frequency
Subsets SU All frequencies in the available
Sub Bands All available frequencies
in all available Sub
Bands Yes