Alvarion BREEZEACCESS SW VERSION 5.1 - Manual (Page 260)

Appendix E - Parameters Summary
BreezeACCESS VL System Manual
228
Parameter Unit Range Default Run-Time
DFS Required by
Regulations ** AU „ No
„ Yes Dependent on Country
Code.
Yes
Frequency Subset
Definition (in AU)** AU According to the Sub-Band. A
list of frequency indexes or A
for all frequencies supported
by the Sub-Band
A
Yes
Channel Check Time** AU 1 – 3600 (seconds) 60 (seconds) Yes
Channel Avoidance
Period** AU 1 – 60 (minutes) 30 (minutes) Yes
SU Waiting Option** AU „ Disable
„ Enable Enable Yes
Minimum Pulses to
Detect** AU 1-100 4 for FCC
8 for other (ETSI) Yes
Clear radar Detected
Channels After Reset** AU „ Disable
„ Enable Disable Yes
Channel Reuse Option** AU „ Disable
„ Enable Disable Yes
Radar Activity
Assessment Period** AU 1 – 12 hours 5 hours Yes
Maximum Number of
Detections in
Assessment Period** AU 1 – 10 detections 5 detections Yes
Country Code Learning
by SU AU „ Disable
„ Enable Disable Yes
Transmit Power AU, SU -10 dBm to a value that
depends on HW revision ,
Country Code / Antenna Gain
and (in SU) the Max Tx Power
parameter The highest allowed
value Yes
Maximum Tx Power SU -10 dBm to a value that
depends on HW revision and
Country Code / Antenna Gain The highest allowed
value Yes
ATPC Option AU, SU „ Disable
„ Enable Enable Yes
Delta from Minimum SNR
Level AU 4-20 (dB) „ Units in 0.9, 5.4, 5.8
GHz bands: 5 (dB)
„ Units in the 4.9, 5.2
and 5.3 GHz bands:
8 (dB)
Yes
Minimum SNR Level AU 4-60 (dB) 28 (dB) Yes
Minimum Interval
Between ATPC
Messages AU 1-3600 (seconds) 30 (seconds) Yes
ATPC Power Level Steps AU 1-20 (dB) 4 Yes
Tx Control AU „ Off
„
On
„ Ethernet Status Control
On Yes
Antenna Gain AU,
SU*** Minimum: 0 (dBi)
Maximum: 50 or Regulation
Max EIRP+10 (the lower of the
two values). According to the antenna
supplied with the unit.
No