2 and with edge detection, 3 nand (not and), And with edge detection – IDEC FL1E SmartRelay User Manual
Page 130: Nand (not and)
IDEC SmartRelay functions
116
IDEC SmartRelay Manual
4.2.2
AND with Edge Detection
Symbol in IDEC SmartRelay:
The output of an edge triggered AND is only 1 if all inputs are
1 and if at least one input was low in the previous cycle.
At an unused block input (x): x = 1.
1
Cycle
3
Q
2
1
2
3
4
5
6
7
8
9
10
4
Timing diagram for the AND with Edge Detection
4.2.3
NAND (not AND)
Parallel circuit with multiple normally
closed contacts in the circuit diagram:
Symbol in IDEC
SmartRelay:
The output of the NAND is only 0 if the status at all inputs is
1, i.e. the contacts are closed.
At an unused block input (x): x = 1.