IDEC FL1E SmartRelay - Manual (Page 112)

Programming IDEC SmartRelay
98 IDEC SmartRelay Manual 
To enable/disable automatic S/W Time conversion in
parameter assignment mode:
If you want to enable/disable automatic S/W Time
conversion in parameter assignment mode, select in the
parameter assignment menu ’Set..’, then menus ’Clock’ and
’S/W Time’. You can now enable/disable automatic S/W
Time conversion.
Enabling summertime/wintertime conversion
You now want to enable this conversion and define or set its
parameters:
1. Move the ’>’ cursor to ’On’:
Press or
2. Confirm ’On’: Press OK
The display shows:
EU
3. Select the desired conversion: Press or
What is shown on the display ?:
• ’EU’ represents the start and end of European
summertime.
• ’UK’ represents the start and end of summertime in the
United Kingdom.
• ’US1’ represents the start and end of daylight saving time
(summertime) in the United States prior to 2007.
• ’US2’ represents the start and end of daylight saving time
(summertime) in the United States in 2007 and later
years.
• ’AUS’ represents the start and end of Australian
summertime.
• ’AUS-TAS’ represents the start and end of Australian/
Tasmanian summertime.
• ’NZ’ represents the start and end of New Zealand
summertime.
• . . : Here you can enter any month, day and time zone
difference.