Anritsu Series MS278XB - Manual (Page 134)

Parameter Entry and Measurement Setup Dialog Archive Front Panel Menus
4-36 MS278XB OM
4-4 Parameter Entry and Measurement Setup Dialog Archive
This property and dialog menu archive illustrates the following set of property sheets and other dialog menus
contained in the MS278XB GUI:
• Occupied Bandwidth Setup Dialog
• Channel Power Setup Dialog
• Adjacent Channel Power (ACP) Setup Dialog
• Multicarrier Channel Power Setup Dialog
• VSA Modulation Parameters Setup Dialog
• WCDMA Graph Type Dialog
• WCDMA Setup Dialog
• TPC Limit Edge Definition Dialog
• Channel Table Editor Dialog
• Customize Tool Bar Dialog
• Options Dialog
• MATLAB Setup Dialog
The structure follows that of what one would encounter when normally interfacing with the analyzer.
Occupied Bandwidth Setup Dialog
Occupied Bandwidth integrates the power of the displayed spectrum and puts markers at the bandwidth limits
as specified in the measurement setup fields. The measurement defaults to 99% of the occupied bandwidth.
OBW Tab % Power: Sets the limits for the occupied bandwidth
measurement by specifying the percentage of power
included in the measured bandwidth.
Range: 10% to 100% in steps of 1%
Default: 99%
X dB: Sets the limits down from the carrier peak for which
occupied bandwidth is measured.
Range: 0.1 dB to 100 dB in steps of 0.1 dB
Default: 26 dB
Figure 4-13. Occupied Bandwidth Setup Dialog