IronPort Systems 4108GL User Manual
Page 460
A-18
File Transfers
Copying Diagnostic Data to a Remote Host, PC, or Unix Workstation
Fil
e
T
ran
sf
e
rs
Copying Crash Log Data Content to a Destination Device
This command uses TFTP or Xmodem to copy the Crash Log content to a PC
or UNIX workstation on the network. You can copy individual slot information
or the master switch information. If you do not specify either, the command
defaults to the master data.
Syntax:
copy crash-log [<slot-id | master>] tftp <ip-address>
copy crash-log [<slot-id | master>] xmodem
where:
slot-id = a - h, and retrieves the crash log or crash data from
the processor on the module in the specified slot.
master
Retrieves crash log or crash data from the switch’s
chassis processor.
For example, to copy the Crash Log for slot C to a file in a PC connected to
the switch:
Figure A-10. Example of sending a Crash Log for Slot C to a File on an Attached PC
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.