IronPort Systems 4108GL User Manual
Page 108
6-6
Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
In
te
rf
ace
Ac
cess
an
d
Syst
e
m
In
fo
rm
a
tio
n
Reconfigure Web Browser Access.
In the default configuration, web
browser access is enabled.
Syntax:
[no] web-management
To disable web browser access:
HP4108(config)# no web-management
To re-enable web browser access:
HP4108(config)# web-management
Reconfigure the Console/Serial Link Settings.
You can reconfigure one
or more console parameters with one console command.
Syntax:
console
[terminal
[screen-refresh <1 | 3 | 5 | 10 | 20 | 30 | 45 | 60>]
[baud-rate
[flow-control N o t e If you change the Baud Rate or Flow Control settings for the switch, you All console parameter changes except events require that you save the config- uration with write memory and then execute boot before the new console configuration will take effect. For example, to use one command to configure the switch with the following: ■ VT100 operation ■ 19,200 baud ■ No flow control ■ 10-minute inactivity time ■ Critical log events you would use the following command sequence:
[inactivity-timer <0 1 5 10 15 20 30 60 120>]
[events
should make the corresponding changes in your console access device. Oth-
erwise, you may lose connectivity between the switch and your terminal
emulator due to differences between the terminal and switch settings for these
two parameters.