Disabling time synchronization, Sntp: viewing, selecting, and configuring, Disabling time synchronization -4 – IronPort Systems 4108GL User Manual
Page 134: Sntp: viewing, selecting, and configuring -4

8-4
Time Protocols
SNTP: Viewing, Selecting, and Configuring
Ti
m
e
Pr
ot
o
c
o
ls
Note that simply selecting a time synchronization protocol does not enable
that protocol on the switch unless you also enable the protocol itself (step 2,
above). For example, in the factory-default configuration, TimeP is the
selected time synchronization method. However, because TimeP is disabled
in the factory-default configuration, no time synchronization protocol is
running.
Disabling Time Synchronization
You can use either of the following methods to disable time synchronization
without changing the Timep or SNTP configuration:
■
In the System Information screen of the Menu interface, set the
Time
Synch Method
parameter to
None
, then press
[Enter], then [S] (for
Save
).
■
In the Global config level of the CLI, execute
no timesync
.
SNTP: Viewing, Selecting, and
Configuring
SNTP Feature
Default
Menu
CLI
Web
view the SNTP time synchronization configuration
n/a
—
select SNTP as the time synchronization method
timep
—
disable time synchronization
timep
—
enable the SNTP mode (Broadcast, Unicast, or Disabled)
disabled
—
broadcast
n/a
—
unicast
n/a
—
none/disabled
n/a
—
configure an SNTP server address (for Unicast mode only) none
page 8-10 ff.
—
change the SNTP server version (for Unicast mode only)
3
—
change the SNTP poll interval
720 seconds
—