IronPort Systems 4108GL User Manual
Page 240

12-10
Configuring for Network Management Applications
Overview
Mo
ni
to
ri
n
g
a
n
d
M
a
na
gi
ng
th
e
S
w
itc
h
In the next example, the
show snmp-server command shows that the switch
has been previously configured to send SNMP traps to management stations
belonging to the “public”, “red-team”, and “blue-team” communities.
Figure 12-4. Example of Show SNMP-Server Listing
Configuring Trap Receivers.
This command specifies trap receivers by
community membership, management station IP address, and the type of
Event Log messages to send to the trap receiver.
N o t e
If you specify a community name that does not exist—that is, has not yet been
configured on the switch—the switch still accepts the trap receiver assign-
ment. However, no traps will be sent to that trap receiver until the community
to which it belongs has been configured on the switch.
Syntax:
snmp-server host
<community-str> <ip-address> [
For example, to configure a trap receiver in a community named "red-team"
with an IP address of 10.28.227.130 to receive only "critical" log messages:
HP4108(config)# snmp-server trap-receiver red-team
10.28.227.130 critical
Example of
Community
Name Data (See
page 12-5.)
Example of Trap
Receiver Data
Authentication
Trap Setting