Blackmagic Design DaVinci Resolve Studio (Dongle) User Manual
Page 111
96
Lesson 4
Assembling a R
ough Cut
2
Position the playhead between the two interview clips in the timeline. As you drag,
the playhead should snap to the cut point, ensuring that you are in the right spot.
TIP
The snapping behavior can be disabled by clicking the snapping button
in the toolbar, or pressing N.
3
In the bin list, click the B-Roll smart bin, and double-click the
08_SOUTH_POLE_DC3
clip to load it into the source viewer.
4
Move to the start of the clip and press spacebar to play this clip.
The clip of a plane taking off from the South Pole is a good one to add between these
two interview clips because it goes with his comments about getting impossible shots.