Roland TM-6 Pro Drum Trigger Module - Manual (Page 9)

9
Getting Ready
Mounting the TM-6 PRO on the Stand
By using an all purpose clamp (sold separately: APC-33), you
can attach the TM-6 PRO to a hi-hat stand or cymbal stand.
You can also attach it to a pad stand (sold separately: PDS-10).
* Do not use any screws except those that are included
with the TM-6 PRO. Using other screws might cause
malfunctions.
* When turning the unit over, be careful so as to protect
the buttons and knobs from damage. Also, handle the
unit carefully; do not drop it.
Mounting the TM-6 PRO on the all purpose
clamp
Wide
Narrow
Mounting
plate
* You must install the mounting plate in the orientation
that’s shown in the illustration. If the orientation is
incorrect, it will contact the stand and cannot be
attached.
MEMO
The all purpose clamp can be attached to a pipe with a
diameter in the range 10.5–28.6 mm.
Example of attachment to stand
Mounting the TM-6 PRO on the pad stand