Roland TM-6 Pro Drum Trigger Module - Manual (Page 8)

8
Getting Ready
FOOT SW jack
You can connect
a footswitch (sold
separately: BOSS FS-5U,
FS-6) here and use it to
control various things
(p. 43).
HH CTRL jack
By using this in conjunction
with the TRIGGER IN 6 jack you
can play open/closed hi-hat
sounds.
* Only instruments of the hi-
hat category support this.
TRIGGER IN 1–6 jacks
You can connect acoustic drum triggers (sold separately:
RT series), bar trigger pads (sold separately: BT-1), or pads
(sold separately: PD/PDX series) etc. to these jacks (p. 11).
To make connections, use the cable that’s included with
each trigger or pad.
PHONES jack
Connect your
headphones here.
Even if headphones are
connected, sound is
output from the various
output jacks.
MASTER OUT jack
These jacks output the sound.
Connect them to amplified
speakers or a mixer.
If you’re connecting to an
amp that has mono input, set
the Master Mono Sw ([MENU]
button 0 SYS 0 Output
Assign (SETUP tab))
appropriately (p. 38).
DIRECT OUT 1–4 jacks
Connect these jacks to your mixer,
etc.
The Output Assign ([MENU]
button 0 SYS 0 Output Assign)
settings specify the DIRECT
OUT 1–4 jack from which each
instrument is output (p. 38).
DC IN jack
Connect the included AC adaptor here.
* Place the AC adaptor so the side with the indicator (see illustration) faces upwards
and the side with textual information faces downwards. The indicator will light
when you plug the AC adaptor into an AC outlet.
* Use the cord hook to secure the cord of the AC adaptor as shown in the illustration.
[POWER] switch
Press this switch
to turn it on/off
(p. 10).
Rear Panel (Connect Your Equipment)
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any
connections.
Indicator