Roland TM-6 Pro Drum Trigger Module - Manual (Page 20)

20
Selecting a Kit
1 Press the [EXIT] button several times to
access the KIT screen.
2 Press the [–] [+] buttons to select a kit.
About the KIT screen
This screen is the basic screen of the TM-6 PRO; it appears
when you turn on the power.
Tempo (shown only if kit
tempo is “ON” ( & PDF))
Trigger meter
(Level of the trigger
signal received
when you strike a
drum trigger)
User sample icon (shown
only if the selected kit
uses a user sample (p. 29))
Currently selected drum
trigger
Example)
1H: Head (trigger 1)
1R: Rim (trigger 1)
H&R icon (shown only if H&R
(p. 24) is “ON”)
Kit number and
name
[F1] (SETLIST) button
By pressing the [F1] (SETLIST) button, you can recall kits
in the order in which you registered them in a set list.
Press the [F1] (SETLIST) button once again to return to
the KIT screen.
For details, refer to “Recalling Kits Successively (SET LIST)”
(p. 34).
[F2] (TOOLS) button
This button accesses the following kit-related settings.
For details, refer to “Convenient Functions” (p. 33).
Undo
Returns changes that you made
to a kit or instrument to the state
immediately after the kit was
selected.
Copy
Copies the settings of a kit or drum
trigger.
SETLIST Edit Edit a set list.
1KIT Save
Backs-up the settings of a kit to an
SD card.
1KIT Load
Loads 1 kit backup settings that were
saved to an SD card.
[F3] (KIT VOL) button
This lets you adjust the volume of the kit or hi-hat while
watching a level meter (p. 27).
Playing with the Click
Turning the click on/off
1 Press the [CLICK] button.
The CLICK screen appears.
2
Press the [F3] (CLICK) button.
The click sounds.
You can adjust the volume of the click using the [CLICK]
knob.
3 Press the [F3] (CLICK) button once again.
The click stops.
MEMO
5 You can also turn the click on/off by holding down the
[ENTER] button and pressing the [CLICK] button.
5 The click is output only to the headphones
(by default), but you are free to specify the output
destination. For details, refer to “Audio Output
Assignments” (p. 38).
Changing the tempo
1 In the CLICK screen (TEMPO tab), press the
[–] [+] buttons to adjust the tempo.
MEMO
5 You can specify the tempo by striking a drum trigger
or pressing a trigger button at the desired timing
interval (tap tempo) (SETUP tab 0 Tap Sw, Tap Pad).
5 If the Sync Mode ( & PDF) is set to “EXTERNAL,” the
tempo is shown as “USB.” In this case, you can’t change
the tempo.
Changing the beat unit
1 Access the CLICK screen (SETUP tab).
2 Use cursor buttons to select “Beat,” and
use the [–] [+] buttons to change the time
signature setting.
MEMO
For other settings, refer to “Data List” (PDF).
Performing