Roland TM-6 Pro Drum Trigger Module - Manual (Page 41)

41
Settings (MENU)
3 Use the cursor buttons to select “SD Card
Format,” and then press the [ENTER] button.
The SD CARD FORMAT screen appears.
4 Press the [F3] (EXECUTE) button.
A confirmation message appears.
If you decide to cancel, select “CANCEL” and press the
[ENTER] button.
5 Select “OK” and then press the [ENTER]
button.
The SD card will be formatted.
Connecting to a Computer for Playback
You can connect the TM-6 PRO to a computer, and record
audio or MIDI.
USB cable
(sold separately)
NOTE
5 For some types of computer, this might not work
correctly. Refer to the Roland website for details on
the operating systems that are supported.
5 A USB cable is not included. You can purchase one
from the dealer where you purchased the TM-6 PRO.
5 Use a USB 2.0 cable.
5 Your computer’s USB port must support USB 2.0 Hi-
Speed.
USB Driver Installation and Settings
The USB driver is software that transfers data between the
TM-6 PRO and your computer software.
In order to transmit and receive audio as USB AUDIO, you
must install the USB driver.
Installing the USB driver
For details on downloading and installing the USB driver,
refer to the Roland website.
http://www roland com/support/
MEMO
Before you install the USB driver, change the TM-6 PRO’s
USB driver setting to “VENDOR ”
Changing the USB driver setting
Here’s how to switch between the TM-6 PRO’s dedicated
USB driver and the driver provided by your operating
system.
1 In the SYSTEM screen (p. 38), select “USB
Setup” and press the [ENTER] button.
The USB SETUP screen appears.
2 Press the [F1] (DRIVER) button.
3 Press the [–] [+] buttons to change the value.
Parameter Value Explanation
Driver Mode
GENERIC
Use the driver provided
by the operating system.
Operation is limited to
USB MIDI.
VENDOR
Use the TM-6 PRO’s
dedicated driver
provided by Roland.
USB MIDI and USB audio
can be used.
MEMO
When you change the USB driver setting, the following
message appears.
The USB driver setting becomes effective when you turn
the unit off and then on again.
4 Turn the power off, and then on again.