KACO Powador XP500-XP550-HV TL outdoor - Manual (Page 17)

Page 18 Operating Instructions Powador XP500/550-OD-TL
S t o r a g e / I n s t a l l a t i o n / S t a r t - u p
5 Storage/Installation/Start-up
5.1 Storage
When inverters are in storage, the following conditions are required. If not, this may cause failures. The com-
pany will not be responsible for the problems if following condition is not observed.
• The unit should be stored indoor in its original packaging when it’s being stored more than 6 months. If its
original packaging is removed, it should be stored indoor in a cool, dry place.
• When the unit is stored outdoor, please keep the remained original packaging and do not leave the unit out-
side for long term period.
• Storage temperature: -20°C ~ +70°C
• When inverter is stored under high humidity condition for long term period, it has to be dried out suffi ciently
more than 1 day before connecting to the power.
CAUTION
Inverter Storage Caution
Inverters need to be sotred at the correct temperature and correct humidity. If not,
this may cause failures.
5.2 Transporting the unit to the installation location
Once it has arrived at the installation location, the inverter may be transported using the designated eyebolts
or fork-lift. These are located on the top of the inverter housing.
CAUTION
Impact hazard, risk of breakage to the inverter
The centre of gravity is located in the upper part of the inverter.
› Transport the inverter in an upright position.
Transporting the inverter
Transporting the inverter using eyebolts
 Transport the inverter in an upright position.
 Connection the rope to the two eyebolts on the left.
 Connection the rope to the two eyebolts on the right.
 Attach both ropes to a hook, making sure that the ropes do not cross each other.
*The rope length: 1650mm over
 Position the hook at the middle of the unit.
Transporting the inverter using fork-lift
 Remove the front cover of base frame.