Yaskawa JAPMC-MC2303-E User Manual
Page 104
6
Message Send and Receive Functions
6.2 Message Receive Function
6.2.3 Inputs and Outputs for the Message Receive Function
6-19
[ d ] Pro-Typ (Communication Protocol)
The Pro-Typ input specifies the communication protocol as shown in the following table.
The following table summarizes the correspondence between the FL-net message and Pro-Typ.
∗ 1. Because a response is sent from within the 262IF-01, neither receive processing by applications (MSG-RCV func-
tion) nor send processing by applications (MSG-SND function) is required.
∗ 2. A response is received by application send processing (MSG-SND function). The MSG-RCV function is not
required.
For the relationship between the FL-net message and message function, refer to 6.3 Combination of FL-net Mes-
sages and Message Functions on page 6-29.
[ e ] Cir-No (Circuit Number)
The Cir-No input specifies the circuit number of the transmission device.
Set the circuit number to the value displayed in the MPE720 Module Configuration Window.
The valid circuit number range of FL-net is 1 to 8.
Type code
Communication Protocol
Remarks
1
MEMOBUS
Select for word block read or word block write of FL-net messages.
2
Non-procedure protocol 1
(in units of words)
Select for other than the above message.
Data will be received in word units using the non-procedure protocol. No
response is sent to the remote station.
3
Non-procedure protocol 2
(in units of bits)
Not used in FL-net.
Message Type
Function
Communication Protocol
Server
(Send
Response)
Client
(Send Request)
Word block read
Reads data in units of words.
MEMOBUS
–
*2
Word block write
Writes data in units of words.
MEMOBUS
–
*2
Network parameter read
Reads network parameter data.
–
*1
Non-procedure 1
Network parameter write
Writes network parameter data.
Not supported
Non-procedure 1
Stop command
Stops operation of equipment such as the PC connected
to the upper layer of the FA link protocol.
Not supported
Non-procedure 1
Start command
Starts operation of equipment such as the PC connected
to the upper layer of the FA link protocol.
Not supported
Non-procedure 1
Profile read
Reads a device profile.
–
*1
Non-procedure 1
Transparent message
Provides a transparent service to the upper layer of the
FA link protocol.
Non-procedure 1
Non-procedure 1
Log data read
Reads log data concerning a specified node.
–
*1
Non-procedure 1
Log data clear
Clears log data concerning a specified node.
–
*1
Non-procedure 1
Message loopback
Loops back a received message.
–
*1
Non-procedure 1
Circuit number