1 functions on digital operator, 1 connecting the digital operator – Yaskawa Sigma II Series DC Power Input SGMAJ User Manual

Page 146

7 Digital Operator

7.1.1 Connecting the Digital Operator

7-2

7.1 Functions on Digital Operator

This section describes the basic operations of the digital operator (hereinafter called the digital operator) for set-
ting the operating conditions. Set parameters and JOG operation, and display status using these operators. For
the detailed operation of the digital operator (Model: JUSP-OP02A-2), refer to

Σ-II Series SGMH/SGDM Dig-

ital Operator Operation Manual (TOE-S800-34).

7.1.1 Connecting the Digital Operator

There is no need to turn OFF the SERVOPACK to connect this hand-held operator to the SERVOPACK. Refer to
the following illustrations to connect the digital operator to the SERVOPACK.

Digital Operator

Hand-held

JUSP-OP02A-2

A dedicated cable is used to
connect the digital operator
to the SERVOPACK.

RESET

ALARM

SERVOPACK

. . . . .

DIGITAL

OPERATOR

JUSP-OP02A

YASKAWA

DSPL

SET

DATA

ENTER

JOG

SVON

CN3

SERVOPACK