HEIDENHAIN iTNC 530 (60642x-03) - Manual (Page 734)

734
M109
M110
M111
Constant contouring speed at tool cutting edge
(increase and decrease feed rate)
Constant contouring speed at tool cutting edge
(feed rate decrease only)
Reset M109/M110 


Page 384
M114
M115 Automatic compensation of machine geometry when working with tilted axes
Reset M114 

Page 509
M116
M117 Feed rate for rotary axes in mm/min
Reset M116 

Page 506
M118 Superimpose handwheel positioning during program run  Page 387
M120 Pre-calculate radius-compensated contour (LOOK AHEAD)  Page 385
M124 Do not include points when executing non-compensated line blocks  Page 378
M126
M127 Shortest-path traverse of rotary axes
Reset M126 

Page 507
M128
M129 Retain position of tool tip when positioning tilting axes (TCPM)
Reset M128 

Page 511
M130 Moving to position in an untilted coordinate system with a tilted working plane  Page 376
M134
M135 Exact stop at nontangential contour transitions when positioning with rotary axes
Reset M134 

Page 514
M136
M137 Feed rate F in millimeters per spindle revolution
Reset M136 

Page 383
M138 Selection of tilted axes  Page 514
M140 Retraction from the contour in the tool-axis direction  Page 388
M141 Suppress touch probe monitoring  Page 389
M142 Delete modal program information  Page 390
M143 Delete basic rotation  Page 390
M144
M145
Compensate the machine’s kinematics configuration for ACTUAL/NOMINAL positions
at end of block
Reset M144 

Page 515
M148
M149 Retract the tool automatically from the contour at NC stop
Reset M148 

Page 391
M150 Suppress limit switch message (function effective blockwise)  Page 392
M200
M201
M202
M203
M204 Laser cutting: Output programmed voltage directly
Laser cutting: Output of voltage as a function of distance
Laser cutting: Output of voltage as a function of speed
Laser cutting: Output of voltage as a function of time (ramp)
Laser cutting: Output voltage as a function of time (pulse) 




Page 393
M Effect Effective at block... Start End Page