HEIDENHAIN iTNC 530 (60642x-03) - Manual (Page 723)

HEIDENHAIN iTNC 530 723
1
9
.1 Intr
oduction
Switching to Windows interface
Usually Windows runs on the third desktop of the TNC:
 Use the Split Screen key to switch to the third desktop
Exiting Windows
Your machine tool builder configures the TNC and
Windows. The machine tool builder determines the
control desktop on which Windows runs.
Before shutting down the TNC you must terminate
Windows 7 on the IPC. Direct switch-off via the master
switch of the machine tool can cause data loss or a defect
in the Windows system.