HEIDENHAIN iTNC 530 (60642x-03) - Manual (Page 212)

212 Programming: Tools
5.3 T
ool compensation
Entering radius compensation
Radius compensation is entered in an L block: Enter the coordinates
of the target point and confirm your entry with ENT
Select tool movement to the left of the contour: Press
the RL soft key, or
Select tool movement to the right of the contour:
Press the RR soft key, or
Select tool movement without radius compensation
or cancel radius compensation: Press the ENT key
Terminate the block: Press the END key
RADIUS COMP.: RL/RR/NO COMP.?