HEIDENHAIN iTNC 530 (60642x-03) - Manual (Page 733)

HEIDENHAIN iTNC 530 733
Miscellaneous functions
M Effect Effective at block... Start End Page
M0 Program run STOP/Spindle STOP if necessary/Coolant OFF if necessary  Page 373
M1 Optional program STOP/Spindle STOP/Coolant OFF (machine-dependent)  Page 647
M2 Program run STOP/Spindle STOP/Coolant OFF/Clear status display
(depending on machine parameter)/Go to block 1  Page 373
M3
M4
M5 Spindle ON clockwise
Spindle ON counterclockwise
Spindle STOP 


Page 373
M6 Tool change/Stop program run (depending on machine parameter)/Spindle STOP  Page 373
M8
M9 Coolant ON
Coolant OFF 

Page 373
M13
M14 Spindle ON clockwise/Coolant ON
Spindle ON counterclockwise/Coolant ON 
 Page 373
M30 Same function as M2  Page 373
M89 Vacant miscellaneous function or
Cycle call, modally effective (depending on machine parameter) 

Cycles
Manual
M90 Only in following error mode: Constant contouring speed at corners  Page 377
M91 Within the positioning block: Coordinates are referenced to machine datum  Page 374
M92 Within the positioning block: Coordinates are referenced to position defined by
machine tool builder, such as tool change position  Page 374
M94 Reduce the rotary axis display to a value below 360°  Page 508
M97 Machine small contour steps  Page 379
M98 Machine open contours completely  Page 381
M99 Blockwise cycle call  Cycles
Manual
M101
M102 Automatic tool change with replacement tool if maximum tool life has expired
Reset M101 
 Page 196
M103 Reduce feed rate during plunging to factor F (percentage)  Page 382
M104 Reactivate the datum as last defined  Page 376
M105
M106 Machining with second k
v
factor
Machining with first k
v
factor


Page 690
M107
M108 Suppress error message for replacement tools with oversize
Reset M107 

Page 196