HEIDENHAIN iTNC 530 (60642x-03) - Manual (Page 161)

HEIDENHAIN iTNC 530 161
4.6 Immediat
e help f
o
r NC er
ro
r messag
es
4.6 Immediate help for NC error
messages
Displaying error messages
The TNC automatically generates error messages when it detects
problems such as
 Incorrect data input
 Logical errors in the program
 Contour elements that are impossible to machine
 Incorrect use of touch probes
An error message that contains a program block number was caused
by an error in the indicated block or in the preceding block. The TNC
error messages can be canceled with the CE key, after the cause of
the error has been removed. Error messages causing a control crash
must be acknowledged by pressing the END key. The TNC will restart.
If you require more information on a particular error message, press
the HELP key. A pop-up window then appears, in which the cause of
the error is explained and suggestions are made for correcting the
error.
Display HELP
 To display Help, press the HELP key
 Read the cause of error and any suggestions for
possible remedies. The TNC may show additional
information that can be helpful to trained
HEIDENHAIN personnel during troubleshooting.
Close the Help window with the CE key, thus
canceling the error message
 Remove the cause of the error as described in the
Help window