HEIDENHAIN iTNC 530 (60642x-03) - Manual (Page 18)

New functions in v
e
rsion 60642x
-03
18
New functions in version 60642x-03
 New software option Active Chatter Control (ACC) (see "Active
Chatter Control (ACC; software option)" on page 445)
 Improvement of Dynamic Collision Monitoring (DCM):
 For the NC syntax SEL FIXTURE, the software now supports a
selection window with file preview for selecting saved fixtures
(see "Loading fixtures under program control" on page 415)
 The nesting depth for program calls has been increased from 10 to
30 (see "Nesting depth" on page 297)
 When using the second Ethernet interface for a machine network,
you can now also configure a DHCP server to provide the machines
with dynamic IP addresses (see "General network settings" page
660 ff)
 Machine parameter 7268.x can now be used to arrange or hide
columns in the datum table (see "List of general user parameters"
page 691 ff)
 The SEQ switch of the PLANE function can now also be assigned a
Q parameter (see "Selection of alternate tilting possibilities: SEQ +/–
(entry optional)" on page 497)
 Improvements to the NC editor:
 Saving a program (see "Deliberately saving changes" on page 112)
 Saving a program under another name (see "Saving a program to
a new file" on page 113)
 Canceling changes (see "Undoing changes" on page 113)
 Improvements to the DXF converter:(see "Processing DXF files
(software option)" page 270 ff)
 Improvements to the status bar
 The DXF converter saves various pieces of information when it is
exited and restores them when it is recalled
 The desired file format can now be selected when saving
contours and points
 Machining positions can now also be saved to programs in
conversational format
 DXF converter now in new look and feel if the DXF file is directly
opened via the file management