HEIDENHAIN iTNC 530 (60642x-03) - Manual (Page 338)

338 Programming: Q parameters
9.8 A
d
ditional functions
Values from global program
settings GS, 332 1 0 Value of basic rotation
2 1 to 9 (X to W) Provides the index of the axis on which the
queried axis was swapped: 1=X, 2=Y, 3=Z, 4=Y,
5=B, 6=C, 7=U, 8=V, 9=W
3 1 to 9 (X to W) Provides 1 if the queried axis is mirrored
4 1 to 9 (X to W) Supplies the shift value of the queried axis
5 0 Provides the active rotation angle
6 0 Provides the active value of the feed-rate override
7 1 to 9 (X to W) Provides 1 if the queried axis is disabled
8 1 to 10 (X to VT) Provides the max. value of the handwheel
superimposition in the queried axis
9 1 to 10 (X to VT) Provides the actual value of the handwheel
superimposition in the queried axis
TS triggering touch probe, 350 10 - Touch probe axis
11 - Effective ball radius
12 - Effective length
13 - Radius setting ring
14 1 Center offset (reference axis)
2 Center offset (minor axis)
15 - Direction of center misalignment compared with
0° position
TT tool touch probe 20 1 Center point X axis (REF system)
2 Center point Y axis (REF system)
3 Center point Z axis (REF system)
21 - Probe contact radius
Last touch point in TCH PROBE
Cycle 0 or last touch point from
manual operating mode, 360 1 1 to 9 Position in the active coordinate system in axes 1
to 9
2 1 to 9 Position in the REF system in axes 1 to 9
Group name, ID no. Number Index Meaning