HEIDENHAIN iTNC 530 (60642x-03) - Manual (Page 12)

Chang
e
d functions in v
e
rsion 60642x
-0
1 since the pr
edecessor v
e
rsions
34049x
-05
12
Changed functions in version
60642x-01 since the predecessor
versions 34049x-05
 Opening and editing of externally created files has been added (see
"Additional tools for management of external file types" on page 141)
 New functions in the task bar have been added (see "Task bar" on
page 94)
 Enhanced functions for configuration of the Ethernet interface (see
"Configuring the TNC" on page 659)
 Improvements regarding functional safety FS (option):
 General information on functional safety (FS) (see "General
information" on page 569)
 Explanation of terms (see "Explanation of terms" on page 570)
 Checking the axis positions (see "Checking the axis positions" on
page 571)
 Activating feed-rate limitation (see "Activating feed-rate limitation"
on page 573)
 Improvements regarding the general status view of a TNC with
functional safety (see "Additional status displays" on page 573)
 The new HR 520 and HR 550 FS handwheels are supported (see
"Traversing with electronic handwheels" on page 557)
 New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool’s contact angle on blocks with surface normal
vectors (LN blocks, see "3-D tool radius compensation depending on
the tool’s contact angle (3D-ToolComp software option)", page 523)
 3-D line graphics is now also possible in full-screen mode (see "3-D
line graphics (FCL2 function)" on page 158)
 A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see "Calling any
program as a subprogram" on page 295)
 DCM: Saving and restoring of fixture situations
 DCM: The form for test program generation now also contains icons
and tooltips (see "Checking the position of the measured fixture" on
page 411)
 DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
 DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired (see "Operating
FixtureWizard" on page 408)
 DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
 DCM: A library with standard chucking equipment is available now
(see "Fixture templates" on page 407)
 DCM: Tool carrier management (see "Tool carrier management
(DCM software option)" on page 416)