14 manual operation and setup – HEIDENHAIN iTNC 530 (60642x-03) User Manual
Page 44
44
14.1 Switch-on, switch-off ..... 552
14.2 Moving the machine axes ..... 555
Moving the axis using the machine axis direction buttons ..... 555
Incremental jog positioning ..... 556
Traversing with electronic handwheels ..... 557
14.3 Spindle speed S, feed rate F and miscellaneous functions M ..... 567
Changing the spindle speed and feed rate ..... 568
14.4 Functional safety FS (option) ..... 569
Explanation of terms ..... 570
Checking the axis positions ..... 571
Overview of permitted feed rates and speeds ..... 572
Activating feed-rate limitation ..... 573
Additional status displays ..... 573
14.5 Datum setting without a touch probe ..... 574
Workpiece presetting with axis keys ..... 575
Datum management with the preset table ..... 576
14.6 Using touch-probes ..... 582
Selecting touch probe cycles ..... 583
Recording measured values from the touch-probe cycles ..... 583
Writing the measured values from touch probe cycles in datum tables ..... 584
Writing the measured values from touch probe cycles in the preset table ..... 585
Storing measured values in the pallet preset table ..... 586
14.7 Calibrating touch probes ..... 587
Calibrating the effective length ..... 587
Calibrating the effective radius and compensating center misalignment ..... 588
Displaying calibration values ..... 589
Managing more than one block of calibrating data ..... 589
14.8 Compensating workpiece misalignment with a 3-D touch probe ..... 590
Basic rotation using 2 points: ..... 592
Determining basic rotation using 2 holes/studs: ..... 594