HEIDENHAIN iTNC 530 (60642x-03) - Manual (Page 582)

582 Manual operation and setup
14.6 Using t
o
uc
h-pr
obes
14.6 Using touch-probes
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Please note that HEIDENHAIN grants a warranty for the
function of the touch probe cycles only if HEIDENHAIN
touch probes are used!
Function Soft key Page
Calibrating the effective length Page 587
Calibrating the effective radius Page 588
Measuring a basic rotation using a line Page 592
Setting the datum in any axis Page 596
Setting a corner as datum Page 597
Setting a circle center as datum Page 598
Setting a center line as datum Page 599
Measuring a basic rotation using two
holes/cylindrical studs Page 600
Setting the datum using four
holes/cylindrical studs Page 600
Setting a circle center using three
holes/cylindrical studs Page 600