Grass Valley NV9000 Web Suite v.1.2 - Manual (Page 30)

20
Options Tab
Configuration Pages
Modifications to any of these fields do not take effect until you click the ‘Save Configuration’
button and the Web Suite service subsequently restarts.
If you make a modification to any field, it turns green or has a green outline until you have saved
the Web Suite configuration.
Note: saving the server’s (i.e., the Web Suite’s) state causes the server to restart. That might take
several minutes.
Descriptions of the fields, buttons, and other items in this page follow.
 If you click the large blue bar at the left of the page (not shown here), the help pane expands
to reveal short help messages regarding the options in this page.
NV9000 IP Address
This is the IP address of the system controller (NV960 or NV920) to which you are connected or
the virtual IP address of a redundant pair of system controllers.
DHP IP Address
If your system controller supports a router that uses DHP, place the system controller’s IP address
in this field too. If your system controller does not support DHP, enter “null” in this field.
 Reminder: DHP allows only one Web Suite connection to be started at any time.
Instrumentation Mode
Place a check mark in this check box if you wish to place the Web Suite in “instrumentation”
mode.
When the Web Suite is in instrumentation mode, all 4 of the pages of the ‘Logs’ subtab under
the ‘Options’ tab are enabled. When instrumentation mode is off, only 3 logging pages are avail-
able. Instrumentation mode also enables more detailed logging.
Save Configuration Button
Click this button to save the Web Suite setup to your PC.
When you save, the Web Suite restarts and your browser refreshes. A restart can take several
minutes.
Restart Application Server Button
Click this button to restart the Web Suite service you have selected. A restart can take several
minutes.
The service being restarted will be unavailable to you (or to others) during this time.
Force Server Data Reload Button
The data affected by this button are what the Web Suite displays. This button tells the server to
reload all the data it collects from all sources.