Grass Valley K2 Dyno S Replay Controller v.3.2 - Manual (Page 76)

Pausing a playlist
1. To add a pause to a single event in the playlist, press Fn and then select the event chevron.
P appears in the chevron next to the selected event. When the playlist playback reaches the event
with the P in the chevron, the playback stops on the last frame of the event.
2. Press Play , Fn | Play or the move the T-bar to resume playback.
3. To assign a pause to all the events in the list, on the PLAYLIST screen tap the All Pause SoftKey.
NOTE: Mark Pauses on the Home screen does not work with clips in Playlist.
PGM/PVW Playlist
1. Tap HOME and then press PGM/PVW .
2. Tap the PLAYLIST tab and select an existing playlist.
3. Press ME/PL 3 times to cue the playlist.
Now notice that event 1 of the playlist is on P1 while event 2 is cued on P2 .
4. Select Play to enable the list to play with each event transferring from P2 to P1 .
Events on P2 can be adjusted or cued while on P2 .
5. Press Take to advance the list to break the PGM/PVW connection.
The Playlist is now played only from P1 , no longer previewing events. Take can still be used to
move clips over to the P1 channel.
6. Putting P2 in to Live and then pressing Take allows a playlist the ability to add a growing clip.
Aux Playlist
1. Tap the HOME tab.
2. Tap the Audio set up panel.
3. Tap the Aux Audio Panel from the bottom strip.
76 K2 Dyno S User Manual 20140207
Playlists