Grass Valley K2 Dyno S Replay Controller v.3.2 - Manual (Page 18)

About loop modes in K2, Dyno, and GV STRATUS
Support for loop modes varies on Grass Valley products.
Grass Valley products provide features for putting an asset into a loop mode. Products and their
loop modes are as follows:
• K2 AppCenter:
• Loop play: Allows the clip to play in a continuous loop until stopped.
• Continuous record: Allows you to specify a fixed-length recording that records continuously.
When the fixed length you specify is reached, AppCenter begins to erase the oldest media in
3 minute segments to make room for new media.
• GV STRATUS:
• Loop play (Loop Playback): Loops the current asset between mark in to mark out.
• K2 Dyno:
• Loop record (LoopRec): Same as K2 AppCenter Continuous record.
While the GV STRATUS application can access the same K2 Storage as K2 AppCenter and K2
Dyno, the GV STRATUS application does not support a recording loop mode. Therefore, in the
GV STRATUS application, do not attempt to access an asset while it is in a loop record mode. The
asset can be put into this type of loop mode by K2 Dyno or K2 AppCenter.
Deleting a Session during startup
You can delete all non-essential Sessions from the Sessions list as follows:
1. Select the session from the list and tap the DELETE softkey.
2. To delete all Sessions currently on the server, press Shift function of the DELETE SoftKey.
Deleting a session while in an active session
To recover space, delete the non-active sessions.
1. To delete the non-active sessions while in an active session, open the CONFIG screen.
2. Tap SESSIONS .
The Sessions list page appears, listing all Sessions currently on the server.
3. Select the session you are deleting and tap DELETE .
You cannot delete an active session, indicated by the word in use in yellow.
18 K2 Dyno S User Manual 20140207
Dyno Startup