Grass Valley K2 Dyno S Replay Controller v.3.2 - Manual (Page 66)

Adding a clip to the end of a playlist
1. Open the PLAYLIST screen.
2. Load the playlist (either new or existing) that requires editing.
3. Go to the tab that has the source clips to be added, either Highlight, Library or Search.
4. Tap the clip to be added to the playlist.
5. To add the clip to the end of the active playlist, press Add PL .
Inserting a clip into the middle of a playlist
1. Open the PLAYLIST screen.
2. Load the existing playlist.
3. Tap the event in the list that plays subsequent to where the new clip is to be inserted.
The event is highlighted in blue.
4. Go to the tab that holds the source clips to be added such as Highlight, Library or Search.
5. Select the clip to be inserted into the list.
6. To add the clip to the selected location, press Add PL .
Adding a group of clips to a Playlist
1. Open the PLAYLIST screen.
2. Load a new or existing playlist.
3. Go to the tab that holds the source clips to be added either Highlight, Library or Search.
4. To add a series of consecutive clips, tap the first clip in the series.
5. Press and hold the Shift button, then tap the last clip in the series.
All the clips between these two slots are highlighted in blue.
6. To add the highlighted clips in an order from first to last to the playlist, press Add PL .
Adding multiple clips to a playlist
1. Open the PLAYLIST screen.
2. Load a new or existing playlist.
3. Go to the tab that holds the source clips to be added either Highlight, Library or Search.
4. To add a series of non-consecutive clips, tap the first clip in the series.
5. Press and hold Fn , then tap a series of clips in the order to be added to the playlist.
6. Release Fn once all the clips are highlighted in blue.
7. To add all the highlighted clips in order from first to last to the active playlist, press Add PL .
66 K2 Dyno S User Manual 20140207
Playlists