Grass Valley K2 Dyno S Replay Controller v.3.2 - Manual (Page 69)

5. Press In or Out respectively.
6. Press Add PL .
The duration of the event is now changed without affecting the original clip in the highlight bin.
Lengthening a clip in a playlist
1. Open the PLAYLIST screen.
2. Cue the playlist to be edited on a playlist channel.
3. To cue the event in the list that requires editing, double-tap the event slot until it is highlighted
in orange.
4. Press Shift | Trim/Take .
On the touch screen, notice that the event is now marked with opposing up and down arrows and
the progress bar is extended representing the guardband space that is now available.
5. Use the Jog Knob to cue the event within the clip to the new event In point or Out point.
6. Press In or Out .
7. Once the new In and/or Out points have been set, press Take .
The event has a new duration without affecting the original clip in the highlight bin.
8. Alternatively, you may do the following to lengthen a clip in a playlist:
a) Repeat Steps 1 to 3 as above.
b) Press
Fn+In to clear an in-point.
c) Use the Jog Knob to select a new in-point.
d) Press
In to set a new In point
e) Press Fn+Out to clear the Out point.
f) Use the Jog Knob to select a new Out point.
g) Press
Out to set new Out point.
Changes are immediately put into effect.
20140207 K2 Dyno S User Manual 69
Playlists