Grass Valley K2 Dyno S Replay Controller v.3.2 - Manual (Page 41)

Playback
Queueing both outputs
1. To control both playback channels, press P1 | P2 buttons simultaneously.
Both P1 | P2 is lit in red.
2. To control both channels, use playback controls as follows:
• T-Bar
• Jog Knob
• Play button
Playback options
The K2 Dyno S Replay Controller has four playback options:
Table 1: Playback options
Description Option
Plays a recorded element or record stream at 100%. This is the
primary way to place any player channel into a playback state. This
works on a playlist, on a highlight, and on the active record trains. The Play button
Plays a recorded element or record stream at a pre-programmed
alternate playback speed, as configured from the
HOME screen.
Alternate playback speed.
Press and hold down the
Fn
key and then press the Play
button.
Immediately takes control of the speed of the active player channel.
Make sure you do not inadvertently touch the T-bar, as doing so
changes the playback speed to the programmed speed of the T-bar. T-bar
The T-bar can be preset with two playback speed configurations:
default and alternate. Alt T-bar
20140207 K2 Dyno S User Manual 41