Grass Valley iMC-Panel-100 v.7.0.9.0 - Manual (Page 53)

Master Control • iMC-Panel-100 Operator’s Guide 41
4. Installation
Display
Display
(This applies to the Planar PT1945R touchscreen display. Other displays might differ.)
Mounting the display
Skip this section if you plan to use the display with its stand, on a flat surface.
1 If the stand is attached to the display, remove it. (There are 4 mounting screws. See the follow-
ing figures.)
2 Using finger pressure, slide the cover of the wiring recess down to remove it:
The wiring recess and the 4 mounting holes are now exposed.
Attach the monitor to your mounting fixture. The mounting holes are tapped for M4 screws and
are 11 mm deep. Use screws of a length appropriate for your mounting fixture.
The monitor has cooling vents at the rear. You should not block the vents.
Remove 4 screws
Remove the cover of the
wiring recess
Recess for Connectors
3.94
[100.0]
3.94
[100.0]