Grass Valley iMC-Panel-100 v.7.0.9.0 - Manual (Page 149)

Master Control • iMC-Panel-100 Operator’s Guide 137
6. Operation
Using the Panel Menu
IP Address
Follow these steps to change the panel’s IP address:
1 From the main menu, press ‘Panel Settings’ to display the ‘Panel Info’ menu. Then press ‘IP
Setup’.
2 Press ‘Change IP’ to display the ‘IP address’ sub-menu. Use the keypads to enter or change the
IP address.
3 Press ‘Change Mask’ to display the ‘Subnet Mask’ sub-menu. Use the keypads to enter or
change the subnet mask.
4 Press ‘Change GW IP’ to display the ‘Gateway IP address’ sub-menu. Use the keypads to enter
or change the IP address.
5 In the keypad menu, press ‘Done’ to save the new IP address or press ‘Cancel’ to discard it. If
you press ‘Done’, the menu will display a message that you must restart the panel to activate
the new IP address: Press ‘OK’ in the alert to proceed. Press ‘Cancel’ to leave the IP address
unchanged.
S Changing the IP address incorrectly can result in an inoperable system, although the problem
can be corrected easily. This is usually the responsibility of the system administrator and done
once and rarely thereafter.