Working with audio monitors, Operation – Grass Valley iMC-Panel-100 v.7.0.9.0 User Manual
Page 133

Master Control • iMC-Panel-100 Operator’s Guide
121
6. Operation
Working with Audio Monitors
Please note: you can “hot cut” overs directly on and off the program bus at any time, as required,
simply by pressing the desired keyer on the program bus. Hot cuts are not recommended.
S
When a voice-over button is selected on the program button row, the corresponding voice-over
button in the main menu becomes highlighted. The voice-over buttons in the main menu also
select a voice-over menu.
S
You cannot change the over source. There is one source for each VO and it is preconfigured.
Working with Audio Monitors
Audio monitoring outputs are available on the CLN (clean-feed) and MON (monitor) outputs of the
Imagestore 750 which provide clean and monitor video outputs respectively.
There are several taps for the CLN and MON video output and there are several taps for the audio
as well.
The monitor levels section of the iMC-Panel-100 has two knobs:
You can adjust the gain of the CLN audio output or the MON audio output simply by turning the
appropriate knob.
The monitoring taps are defined during the configuration of the Imagestore 750.