Grass Valley iMC-Panel-100 v.7.0.9.0 - Manual (Page 52)

40 Rev 1.0 • 29 Nov 11
4. Installation
Button Panel
Button Panel
Rack-mounting the button panel is trivial. It need not be discussed.
If you wish to place the button panel in a recess of a console or desktop, you will need to cut a hole
in the console surface that will fit the button panel. This is a suggested cutout:
The dimensions given above allow 0.01 ″ (0.25 mm) clearance on each edge of the front surface of
the button panel, about 0.125 ″ (3 mm) clearance on each short side of the panel’s enclosure for ven-
tilation. and about 0.06 ″ (1.5 mm) clearance on the long sides of the enclosure.
With recessed mounting, keep in mind that cables must run from the button panel to the display unit
and also to the Ethernet switch for the master control network and to external power supplies
(PS0001).
19.02 [483.1]
17.73 [450.3]
5.10
[129.5]
0.355 [9.0]
0.13R, 4 places
5.24
[133.1]
0.075
— Cut Through —
Drill for 3/16”
screws, 4 places
1.495
[38.0]
2.25
[57.2]