H3C Technologies H3C S6800 Series Switches - Manual (Page 485)

472
Destination: 2002:1::/64 Protocol : Direct
NextHop : :: Preference: 0
Interface : Vlan20 Cost : 0
Destination: 2002:1::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: 2012::/64 Protocol : RIPng
NextHop : FE80::20C:29FF:FE40:701 Preference: 100
Interface : Vlan20 Cost : 1
Destination: FE80::/10 Protocol : Direct
NextHop : :: Preference: 0
Interface : NULL0 Cost : 0
Destination: FF00::/8 Protocol : Direct
NextHop : :: Preference: 0
Interface : NULL0 Cost : 0
The output shows that the MCE has learned the private route of VPN 2. The MCE maintains the
routes of VPN 1 and VPN 2 in two different routing tables. In this way, routes from different VPNs
are separated.
3. Configure routing between the MCE and PE 1:
# On the MCE, configure the port connected to PE 1 as a trunk port, and configure it to permit
packets of VLAN 30 and VLAN 40 to pass with VLAN tags.
[MCE] interface fortygige 1/0/3
[MCE-FortyGigE1/0/3] port link-type trunk
[MCE-FortyGigE1/0/3] port trunk permit vlan 30 40
[MCE-FortyGigE1/0/3] quit
# On PE 1, configure the port connected to MCE as a trunk port, and configure it to permit packets
of VLAN 30 and VLAN 40 to pass with VLAN tags.
[PE1] interface fortygige 1/0/1
[PE1-FortyGigE1/0/1] port link-type trunk
[PE1-FortyGigE1/0/1] port trunk permit vlan 30 40
[PE1-FortyGigE1/0/1] quit
# On the MCE, create VLAN 30 and VLAN-interface 30, bind VLAN-interface 30 to VPN instance
vpn1, and configure an IPv6 address for the VLAN-interface 30.
[MCE] vlan 30
[MCE-vlan30] quit
[MCE] interface vlan-interface 30
[MCE-Vlan-interface30] ip binding vpn-instance vpn1
[MCE-Vlan-interface30] ipv6 address 30::1 64
[MCE-Vlan-interface30] quit
# On the MCE, create VLAN 40 and VLAN-interface 40, bind VLAN-interface 40 to VPN instance
vpn2, and configure an IPv6 address for the VLAN-interface 40.
[MCE] vlan 40