H3C Technologies H3C S6800 Series Switches - Manual (Page 202)

189
Step Command Remarks
7. Configure the CE as a client
of the RR. peer { group-name | ip-address
[ mask-length ] } reflect-client
By default, no RR or RR client is
configured, and the PE does not
advertise routes learned from the
IBGP peer CE to other IBGP
peers, including VPNv4 IBGP
peers. The PE advertises routes
learned from the CE to other
IBGP peers only when you
configure the IBGP peer CE as a
client of the RR.
Configuring an RR does not
change the next hop of a route.
To change the next hop of a
route, configure an inbound
policy on the receiving side.
8. (Optional.) Enable route
reflection between clients.
reflect between-clients
Route reflection between clients
is enabled by default.
9. (Optional.) Configure the
cluster ID for the RR.
reflector cluster-id { cluster-id |
ip-address }
By default, the RR uses its own
router ID as the cluster ID.
If multiple RRs exist in a cluster,
use this command to configure
the same cluster ID for all RRs in
the cluster to avoid routing loops.
2. Configure the CE:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Configure the PE as an IBGP
peer.
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
By default, no BGP peer is
created.
4. Create the BGP IPv4 unicast
family and enter its view.
address-family ipv4 [ unicast ]
By default, the BGP IPv4 unicast
family is not created.
5. Enable IPv4 unicast route
exchange with the specified
peer or peer group.
peer { group-name | ip-address
[ mask-length ] } enable
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
6. (Optional.) Configure route
redistribution.
import-route protocol
[ { process-id | all-processes }
[ med med-value | route-policy
route-policy-name ] * ]
A CE must redistribute its routes
to the PE so the PE can advertise
them to the peer CE.
Configuring routing between PEs
Step Command Remarks
1. Enter system view. system-view N/A