H3C Technologies H3C S6800 Series Switches - Manual (Page 283)

270
Figure 73 Network diagram
Table 23 Interface and IP address assignment
Device Interface IP address Device Interface IP address
CE 1 Loop0 5.5.5.5/32 PE 2 Loop0 2.2.2.2/32
Vlan-int10 10.2.1.1/24 Vlan-int11 172.1.1.2/24
PE 1 Loop0 1.1.1.1/32 Vlan-int13 10.1.1.2/24
Vlan-int10 10.2.1.2/24 Vlan-int15 172.3.1.2/24
Vlan-int11 172.1.1.1/24 PE 3 Loop0 3.3.3.3/32
Vlan-int12 172.2.1.1/24 Vlan-int12 172.2.1.3/24
CE 2 Loop0 4.4.4.4/32 Vlan-int14 10.3.1.2/24
Vlan-int13 10.1.1.1/24 Vlan-int15 172.3.1.3/24
Vlan-int14 10.3.1.1/24
Configuration procedure
1. Configure IP addresses and masks for interfaces as shown in Table 23 , and configure BGP and
MPLS L3VPN. (Details not shown.)
For more information about configuring basic MPLS L3VPN, see "
Configuring basic MPLS
L3VPN ."
2. Configure MPLS L3VPN FRR on PE 2:
# Configure the source IP address of BFD echo packets as 12.1.1.1.
system-view
[PE2] bfd echo-source-ip 12.1.1.1
# Create routing policy frr, and specify the backup next hop as 3.3.3.3 for the route to
4.4.4.4/32.
[PE2] ip prefix-list abc index 10 permit 4.4.4.4 32
[PE2] route-policy frr permit node 10
[PE2-route-policy] if-match ip address prefix-list abc
[PE2-route-policy] apply fast-reroute backup-nexthop 3.3.3.3
[PE2-route-policy] quit
# Use echo-mode BFD to detect the primary route connectivity.
文件中找不到关系 ID 为 rId95 的图像部件。