H3C Technologies H3C S6800 Series Switches User Manual

Page 415

402

[UPE-ldp] quit

# Enable L2VPN.

[UPE] l2vpn enable

# Configure VSI aaa to use LDP to establish a U-PW to NPE 1.

[UPE] vsi aaa

[UPE-vsi-aaa] pwsignaling ldp

[UPE-vsi-aaa-ldp] peer 2.2.2.9 pw-id 500

[UPE-vsi-aaa-ldp-2.2.2.9-500] quit

[UPE-vsi-aaa-ldp] quit

[UPE-vsi-aaa] quit

# Create service instance 10 on FortyGigE 1/0/1 to match all packets.

[UPE] interface fortygige1/0/1

[UPE-FortyGigE1/0/1] service-instance 10

[UPE-FortyGigE1/0/1-srv10] encapsulation default

# Bind service instance 10 to the VSI aaa.

[UPE-FortyGigE1/0/1-srv10] xconnect vsi aaa

Configure NPE 1:
# Configure basic MPLS.

system-view

[NPE1] interface loopback 0

[NPE1-LoopBack0] ip address 2.2.2.9 32

[NPE1-LoopBack0] quit

[NPE1] mpls lsr-id 2.2.2.9

[NPE1] mpls ldp

[NPE1–ldp] quit

# Enable L2VPN.

[NPE1] l2vpn enable

# Configure VSI aaa that uses LDP as the PW signaling protocol, establish a U-PW to the UPE, and
establish N-PWs to NPE 2 and NPE 3.

[NPE1] vsi aaa

[NPE1-vsi-aaa] pwsignaling ldp

[NPE1-vsi-aaa-ldp] peer 1.1.1.9 pw-id 500 no-split-horizon

[NPE1-vsi-aaa-ldp-1.1.1.9-500] quit

[NPE1-vsi-aaa-ldp] peer 3.3.3.9 pw-id 500

[NPE1-vsi-aaa-ldp-3.3.3.9-500] quit

[NPE1-vsi-aaa-ldp] peer 4.4.4.9 pw-id 500

[NPE1-vsi-aaa-ldp-4.4.4.9-500] quit

[NPE1-vsi-aaa-ldp] quit

[NPE1-vsi-aaa] quit

Configure NPE 2:
# Configure basic MPLS.

system-view

[NPE2] interface loopback 0

[NPE2-LoopBack0] ip address 3.3.3.9 32

[NPE2-LoopBack0] quit

[NPE2] mpls lsr-id 3.3.3.9

This manual is related to the following products: