Verifying the configuration – H3C Technologies H3C S6800 Series Switches User Manual

Page 252

239

# Configure PE 3.

[PE3] ip vpn-instance vpn1

[PE3-vpn-instance-vpn1] route-distinguisher 100:1

[PE3-vpn-instance-vpn1] vpn-target 1:1

[PE3-vpn-instance-vpn1] quit

[PE3] interface Vlan-interface11

[PE3-Vlan-interface11] ip binding vpn-instance vpn1

[PE3-Vlan-interface11] ip address 100.1.1.2 24

[PE3-Vlan-interface11] quit

[PE3] bgp 100

[PE3-bgp] ip vpn-instance vpn1

[PE3-bgp-vpn1] peer 100.1.1.1 as-number 65410

[PE3-bgp-vpn1] address-family ipv4 unicast

[PE3-bgp-ipv4-vpn1] peer 100.1.1.1 enable

[PE3-bgp-ipv4-vpn1] import-route direct

[PE3-bgp-ipv4-vpn1] quit

[PE3-bgp-vpn1] quit

[PE3-bgp] quit

# Configure PE 4 and CE 4 in the same way that PE 3 and CE 3 are configured. (Details not
shown.)

Configure MP-IBGP peer relationship between the PEs of the customer carrier to exchange the end
customers' VPN routes:
# Configure PE 3.

[PE3] bgp 100

[PE3-bgp] peer 6.6.6.9 as-number 100

[PE3-bgp] peer 6.6.6.9 connect-interface loopback 0

[PE3-bgp] address-family vpnv4

[PE3-bgp-vpnv4] peer 6.6.6.9 enable

[PE3-bgp-vpnv4] quit

[PE3-bgp] quit

# Configure PE 4 in the same way that PE 3 is configured. (Details not shown.)

Verifying the configuration

Display the public network routing table and VPN routing table on the provider carrier PEs, for

example, on PE 1:
# Verify that the public network routing table contains only routes of the provider carrier network.

[PE1] display ip routing-table

Destinations : 14 Routes : 14

Destination/Mask Proto Pre Cost NextHop Interface

0.0.0.0/32 Direct 0 0 127.0.0.1 InLoop0

3.3.3.9/32 Direct 0 0 127.0.0.1 InLoop0

4.4.4.9/32 ISIS 15 10 30.1.1.2 Vlan12

30.1.1.0/24 Direct 0 0 30.1.1.1 Vlan12

30.1.1.0/32 Direct 0 0 30.1.1.1 Vlan12

30.1.1.1/32 Direct 0 0 127.0.0.1 InLoop0

30.1.1.255/32 Direct 0 0 30.1.1.1 Vlan12

This manual is related to the following products: