beautypg.com

H-vpls using access configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S6800 Series Switches User Manual

Page 414

background image

401

PW State: Up

PW Status Communication: Notification method

PW ID FEC (Local/Remote):

Local AII : (1.1.1.9, 3.3.3.9)

Remote AII : (3.3.3.9, 1.1.1.9)

PW Type : VLAN/VLAN

Group ID : 0/0

Label : 131154/131116

Control Word: Disabled/Disabled

VCCV CV Type: -/-

VCCV CC Type: -/-

MTU : 1500/1500

PW Status : PW forwarding/PW forwarding

H-VPLS using access configuration example

Network requirements

Configure an H-VPLS network using MPLS access to avoid full-mesh PW configuration. The H-VPLS uses

LDP as the PW signaling protocol.

Figure 103 Network diagram

Configuration procedure

1.

Configure an IGP and public tunnels on each PE. (Details not shown.)

2.

Configure UPE:
# Configure basic MPLS.

system-view

[UPE] interface loopback 0

[UPE-LoopBack0] ip address 1.1.1.9 32

[UPE-LoopBack0] quit

[UPE] mpls lsr-id 1.1.1.9

[UPE] mpls ldp

文件中找不到关系

ID 为 rId131 的图像部件。